Dispensers
Their
Applications
Injection of Epoxy & Other Two Component Resins

Low or Gel Viscosity
High or Low Pressures

Low Volume Hydrant Service

Injection Set-Up Adhesive

Chemical Anchoring

Anchors & Dowels

Medium Volume Hydrant Service

Two Component Sealants & Carbon Fiber Saturants

Bonding Pavement Markers

Features Table
Ratio Error
Less than 1% error regardless of ratio, viscosity, or flow rate.
Operation
Pneumatic
Air consumption 3 cfm @ 120 psi 15 cfm @ 120 psi
Reservoirs 10 gallons 37 gallons
Delivery1 1-15 gph 10 – 60 gph
Thinnest material manageable
No limitation
Thickest material manageable
Most gels and abrasive free mastics – samples needed
Resin supply pressure
120 to 2,300 psi
Ratios available
1:1 to 18:1
Shot sizing
Yes – Hard stop
Dispensers
Construction Table
ΠCertification
Yes
Frame
Welded stainless steel
Wet Seals
UHMW wear compensating
Metering pistons and cylinders
6061 Aluminum hard coated or electroless nickel
Fluid valves
Actuated – Stainless steel investment castings & electroless nickel coated balls
Heat & Ceramic Insulation
None
Available
Material valve sequencing
Mechanically actuated via patented COCO™ Module
Weight 41 pounds 330 pounds
Dimensions 10” x 8” x 17” 40” x 28” x 34”
Air Filter Norgren
ARO PUP
Applications

1 Based upon type of material likely to be selected rather than most flowable. The flow rate will also vary with the ratio. Do not use this data In estimating without first consulting with Lily!